Installation
Edge MAXX
2-6
Figure 2-6: Discharge conveyor switch must be in
the UP position.
B
A
Compressed Air Supply Connection
The unit requires a compressed air supply
to drive certain parts of the machine and direct
the laydown of the flatwork onto the discharge
conveyor.
The air must be clean and dry to assure proper
operation and long service life of the pneumatic
components. Also, the air will come into direct
contact with the flatwork.
The compressed air supply must meet the
pressure and airflow requirements noted in the
APPENDIX,
Technical Specifications
.
Required Tools
wrench, Teflon tape or pipe joint
compound
The unit is shipped with the discharge
ribbons secured in the UP position. Before
connecting the air supply make sure:
The strapping on the discharge con-
veyor has been removed.
The DISCHARGE CONVEYOR UP/
DOWN switch is in the UP position
(Figure 2-6, A).
The discharge conveyor safety bracket
is engaged (B).
1.
a)
b)
c)
NOTE:
Do not use copper tubing
or solid pipe for the compressed
air connections. Use a sturdy
flexible hose to accommodate
machine movement.
Run a sturdy, flexible hose from the ex-
ternal compressed air source to the 1/2”
inlet fitting (Figure 2-7, A) at the back of
the left endframe.
Use Teflon tape to assure a leak-proof
connection. If desired, a quick release
coupling may be used.
Open the left endframe door.
Run sturdy flexible tubing from the drain
fitting on the air filter (Figure 2-7, B) down
through one of the holes in the rear of the
endframe and then to an open drain such
as a floor drain. Make sure to provide
adequate tubing to accommodate machine
movement.
Use Teflon tape to assure a leak-proof
connection.
Close the left endframe door.
2.
3.
4.
5.
6.
7.
Figure 2-7: Compressed air inlet fitting and drain
fitting for the main unit.
B
A
TOC
INDEX
Содержание Edge MAXX
