REMOVAL AND INSTALLATION
COMBINATION FLASHER
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS,
REFER
TO
GROUP
8M
-
PASSIVE
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING
WHEEL,
STEERING
COLUMN,
OR
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the fuse access panel by unsnapping it
from the right cowl side trim panel.
(3) Remove the push nut that secures the right
cowl side trim panel to the junction block stud (Fig.
4).
(4) Remove the two screws that secure the right
cowl side trim panel to the right front door opening
trim.
(5) Remove the right cowl side trim panel from the
right cowl side inner panel.
(6) Unplug the combination flasher from the junc-
tion block.
(7) Install the combination flasher by aligning the
flasher terminals with the cavities in the junction
block and pushing the flasher firmly into place.
(8) Connect the battery negative cable.
(9) Test the flasher operation.
Fig. 3 Multi-Function Switch Continuity
Fig. 4 Right Cowl Side Trim Panel Remove/Install
ZJ
TURN SIGNAL AND HAZARD WARNING SYSTEMS
8J - 5
Содержание Colorado 1998
Страница 8: ......
