Chevrolet 1977 light duty truck, Руководство по обслуживанию

Страница: 238 / 861

Fig. 3B-52- Removing D ire ctio na l Signal Wire
Protector
harness cover by pulling toward the lower end o f the
column, be careful not to d am ag e the wires.
11. Remove the three switch m ounting screws and
pull the switch straight up, guid ing the w iring harness
and cover through the column housing (fig. 3B-53).
Installation
CAUTION: It is extrem ely important that only
the specified screws, holts a n d nuts be used at
assembly. Use o f overlength screws could
prevent a portion o f the assembly fr o m
compressing under impact.
1. All except Tilt - Be sure th at the w iring harness
is in the protector. Feed the connector and cover down
through the housing and under the m ounting bracket
(column in vehicle).
Tilt - Feed the connector down through the housing
Fig. 3B -5 4 --ln sta llin g Switch Connector Onto Jacket
Clips
Fig. 3B-53--Removing D irectional Signal Switch
Assem bly
upp er b earin g preload spring and thrust washer off the
end o f the shaft.
6. Remove the directional signal lever screw and
remove the lever.
7. Push the hazard w a rn in g knob in and unscrew
the knob.
8. Remove the three switch m ounting screws.
9. All Colum ns - Pull the switch connector out o f
the bracket on the jacket and feed switch connector
th rough column support bracket and pull switch straight
up, gu id in g the wiring harness through the column
housing and protector.
10. Rem ove wire protector by pulling downward
out o f column with pliers using ta b pro vided (fig. 3B-52).
Tilt Column - Position the direction signal and
sh ifter housing in the "lo w " position. Remove the