Chevrolet 10 Series 1967, Руководство по обслуживанию, Страница: 75 / 605

BODY IB - 13
2. Remove inside door handles with Tool J-7797.
3. Remove screws securing door trim pad.
4. Loosen 3 screws for rear run channel (one screw
located on door edge).
5. Peel rubber run out of metal channel and pull down­
ward (fig. 27).
6
. Rotate channel outward and lift from door access
opening (fig. 28).
7. Reinstall window regulator handle and lower glass
assembly to bottom of door.
8
. Remove ventilator assembly (see above).
9. Slide glass forward to opening notched in regulator
roller channel.
10. Next, slant window glass rearward for complete
disengagement.
11. Lift glass upward, out of door.
Installation
Install glass or sash in reverse order of removal.
WINDOW REGULATOR REPLACEMENT (Fig. 29)
Removal
1. Wind window all the way up.
2. Remove inside door handles with Tool J-7797.
3. Remove door trim pad secured with 4 screws.
4. Remove 4 screws securing regulator to inner panel.
5. Push regulator out of circular opening while holding
rear of assembly, then slide assembly to the notches
in the carrier channel and out through the door ac­
cess hole.
Installation
Install regulator in reverse order of removal, lubricate
regulator gears with lubriplate.
DOOR OPENING WEATHERSTRIP
Side Door Opening Weatherstrip Replacement
Side door sealing incorporates an inner seal. The
inner seal is mounted on the body opening welding flange
(fig. 30) and goes completely around the periphery of the
opening. The molded weatherstrip material is cemented
(fig. 30)
Success of weatherstrip replacement depends entirely
upon the quality of the cement used and the care with
which it is applied. All rust, road dirt and grease or oil
must be completely removed as should all old cement and
bits of old weatherstrip. After removing all foreign ma­
terial from door opening surface, wipe down with prep-
sol or its equivalent. Use only a good quality cement
which is made specially for weatherstrip installation,
following the manufacturer's directions. Proceed as
follows:
1. Open door and block open.
2. Remove sill plate retaining screws and remove sill
plate.
3. Remove side door inner weatherstrip seal.
4. Remove used adhesive from cab door opening with
adhesive or cement remover.
5. Apply adhesive to cab opening.
6
. Install molded corner of inner weatherstrip, starting
where windshield post joins the header panel.
7. Trim inner weatherstrip with a notch as shown in
Figure 30 and butt ends together.
8
. Reinstall sill plate and sill plate retaining screws.
Door Trim Panel Seal Replacement
1. Remove window regulator and door remote control
iNOTE;
TRIM WEATHERSTRIP
AS SHOWN. BUTT
ENDS & CEMENT TOGETHER
TUBULAR SECTION
^//
MUST BE OPEN TO x (7/
PROVIDE AIR PASSAGE/
VIEW A
STRIP WITH SALVAGE
JOINT TO B E " ,
INSTALLED SO THATj
JOINT FALLS IN
§
THIS AREA v
I
F ig . 30 - Door Opening W eatherstrip F ig . 31 - Installing Trim Panel Seal
CHEVROLET TRUCK SERVICE M ANUAL