Page 1 of 2
Figure 1 - BMT-75CM with
BMT-75WA and BDH-7500 Shown
INSTALLATION MANUAL – BMT-75CM
Corner Mount Accessory for BDH-7500
WARNING: Before beginning installation of this product, carefully review
the safeguards and precautions found on page 2 of this manual.
Unpacking
Unpack carefully. This is mechanical equipment and should
be handled with care. If an item appears to have been
damaged in shipment, replace it properly in its carton and
notify the shipper. If any items are missing, notify the
shipper. The shipping carton is the safest container in which
the unit may be transported. Save it for possible future use.
Service
If the unit ever needs repair service, the customer should
contact Chesapeake & Midlantic Marketing for a return
materials authorization (RMA) and shipping instructions.
Care and Maintenance
Perform routine maintenance to keep the unit dust free.
Model Designation
BMT-75CM
CORNER MOUNT for BDH-7500
Description
The BMT-75CM accessory enables the BDH-7500 to be
installed on the corner of a building. The mount is
constructed of powder coated aluminum and includes
stainless steel fasteners. The mount is designed to be used
with the BMT-75WA Wall Mount.
Hardware Kit
3 x Flat Washer
3 x Lock Washer
3 x Screw, #8-32 x 1” Pan Head Phillips
Tools Required
Phillips Head Screwdriver
Appropriate Drill and Bit for Customer-Supplied Mounting
Hardware
Certification
Installation should be performed by a licensed professional
and conform to the National Electrical Code (NEC) and any
applicable local codes.
Installation
1.
Remove unit from packaging.
2.
Hold unit up to installation side and use as a template to
mark mounting hole locations.
3.
Drill out appropriate sized holes for customer-supplied
fasteners and anchors. Each fastener should have a
minimum 200 lbs pull-out strength.
4.
Run network cable to installation site leaving enough
slack to allow cable entry through the mounts and
housing to the camera.
5.
Attach wall mount to corner mount using fasteners
supplied in the corner mount hardware kit.
6.
Run network cable through corner mount and wall mount
before attaching pole mount to pole.
7.
Attach pole mount to installation surface using customer-
supplied fasteners.
8.
Prepare BDH-7500 housing per instructions included with
the unit treating BMT-75WA as the installation surface.
