Chery J11, Руководство пользователя, Страница: 61 / 152

seconds, then repeat the normal
starting procedure. If the engine
still doesn’t start, see
⬙
Failed Start-
ing Procedure
⬙
.
Failed Starting Procedure
The following should be performed if
the engine fails to start after two con-
secutive attempts:
•
Press the accelerator pedal to the
floor and hold it there.
•
Turn the ignition switch to the START
position and crank the engine till it
starts.
•
Once started, release the accelerator
pedal slowly as the engine warms up.
CAUTION!
To prevent damage to the starter, do
not crank the engine for more than 15
seconds at a time. Wait 10 to 15 sec-
onds before trying again.
After Starting
The idle speed will automatically de-
crease as the engine warms up.
Self-Adapting Function Of Engine
Control System
If the battery cable has been removed
from the battery, the vehicle may run
irregularly for a short time after the
cable is reconnected. This is normal
because the engine control system is
readapting to the engine.
Limiting Engine Speed
To protect the engine from over-
speed, the engine is electronically
limited by the Engine Control Module
(ECM).
Starting and Operating Cautions
Exhaust Gases
WARNING!
Engine exhaust gas can injure or kill.
It contains carbon monoxide (CO)
which is colorless and odorless.
Breathing it can cause unconscious-
ness and even death. To avoid breath-
ing CO, follow these safety tips:
•
Do not run the engine in a closed
garage or confined area any longer
than needed before moving your ve-
hicle from the area.
•
If it is necessary to sit in a parked
vehicle with the engine running in
an open area, adjust your heating
or cooling controls to force outside
air into the vehicle. Set the blower
at high speed.
60 – STARTING AND OPERATING YOUR VEHICLE
Chery Automobile Co., Ltd.