74
After having memorised the limit switches, drive the rolling shutter to the opening
position and then perform the following command sequence:
At the end of the sequence, wait until the rolling shutter is completely lowered. From this
moment onwards the motor moves in “Dead Man” mode.
Carry out the following operations:
• Raise the rolling shutter until it enters into the slat tilting zone (first click).
• Lower the rolling shutter until the slats are at their maximum opening point.
• If you wish, raise the rolling shutter until it reaches an intermediate opening of the slats
(preferred opening position).
• Perform the following confirmation sequence: the
rolling shutter will move in sequence to the three
memorised positions: entry into the slat tilting zone,
maximum opening, preferred opening.
• Raise the rolling shutter until it leaves the slat tilting zone (second click).
• Perform the following confirmation sequence:
The rolling shutter will execute the entry into the slat
tilting zone and will open the slats in the preferred opening position.
Functions of the button panel*
Type of Command
Outside of tilting area
In tilting area
UP short
Completely raised
Less light
DOWN short
Completely lowered
More light
UP long
Entry in tilting area
Out of tilting area
Completely raised
DOWN long
Entry in tilting area
Out of tilting area
Completely lowered
sequence DOWN/UP (0.5 sec)
Entry in tilting area
-
sequence UP/DOWN (0.5 sec)
Entry in tilting area
-
* see key to symbols and operational notes
SLAT TILTING MECHANISM SETTING
(Not available on Clima RX)
MODE 1
:
Orientable roller shutter with coupling point for tilting
function above the lower limit.
Only for roller shutter type Persyroll / Multiroll / Supergradhermetic / Supernova.
Not suitable for centralised control units. Not available on Ø 35.
PROGR.
FROM THE WHITE WIRE
E N G L I S H