12
DEVICE CONTROL
META Wired Motor Controller 7 is an “in wall device”, for the multilevel control of
roller shutter motors. It can accurately control the opening and closing of blinds,
curtains, shutters, venetian blinds by using an external switch, or from remote through
a controller.
Controlling the device by External Switches
For the operation of the device within the Z-Wave
TM
network and controlling the loads
connected to the device, control actions are performed on the external switches.
Event
Type of switch
Actions on the switch
Click
Double command button:
UP/DOWN, open/close,
ON/OFF
Press briefly & Release
(when pressed it autonomously
returns to the initial position)
MultiClick=
n
click
Sequence of consecutive
n
clicks
Hold Down
Press longer than click.
After a Hold Down always follows
an UP event.
Up
Release.
The event applies only if there has
been a previous Hold Down event.
E
NG
L
IS
H
The
CONTROL ACTIONS
are
EVENTS
executed on
EXTERNAL SWITCHES
connected to the UP and DOWN terminal of the device which can be
Clicks,
Hold
Down and Up
.
Device status:
ON/OFF/STOP, Open/Close/Stop refers to the fact that the motor
is rotating towards the direction Open/Close or it is stopped.
Result of Control Actions
• Holding down the UP/DOWN button makes the motor move in the relevant direction
and stops it as soon as the button is released (Up event) or the shutter reaches its limit
switch.
• A click ordering an UP/DOWN movement while the motor is moving in opposite
direction, will stop the motor.
• A click ordering an UP/DOWN movement while the motor is moving in the same
direction, will be ignored.
• A single click on the UP/DOWN button makes the motor move until it reaches the limit
switch for UP/DOWN position.
• A double click on the UP/DOWN button makes the motor move until it reaches the
favorite position set for the UP/DOWN position.