Chelsio Communications Terminator 6, Инструкция по установке и эксплуатации, Страница: 282 / 432

Chapter XX. Classification and Filtering
Chelsio Unified Wire for Linux 282
ii. Create filter rule to send packets for 102.1.2.0/24 network out via eth1 interface:
[root@host~]# cxgbtool eth0 filter 100 lip 102.1.2.0/24 hitcnts 1 action
switch eport 1 smac 00:07:43:04:96:48 dmac 00:07:43:12:D4:88
Where,
smac
is the MAC address of eth1 interface on T6/T5 adapter machine and
dmac
is the
MAC address of eth0 interface on Node 2.
iii. Create filter rule to send packets for 102.1.1.0/24 network out via eth0 interface
[root@host~]# cxgbtool eth0 filter 101 lip 102.1.1.0/24 hitcnts 1 action
switch eport 0 smac 00:07:43:04:96:40 dmac 00:07:43:04:7D:50
Where,
smac
is the MAC address of eth0 interface on T6/T5 adapter machine and
dmac
is the
MAC address of eth0 interface on Node 1.
2.6. Layer 2 Example
Here’s an example on how to achieve L2 switching functionality. The following will only work on
kernel 3.10 and above.
•
Follow these steps on Node 1
i. Configure IP address and enable the interface:
[root@host~]# ifconfig eth0 102.1.1.1/24 up
[root@host~]# ifconfig eth0
eth0 Link encap:Ethernet HWaddr 00:07:43:04:7D:50
inet addr:102.1.1.1 Bcast:102.1.1.255 Mask:255.255.255.0
T6/T5
Node 1 Node 2
eth0
eth1
promisc promisc
102.1.1.2/24
102.1.1.1/24
eth0
eth0