- 05 -
- 06 -
3. Rotate Accessory Locking Ring (2) clockwise to
lock it up. Do not over-tighten.
Attaching Flash Tube
1. Remove the reflector or other accessories from
the flash head.
2. Match the red dot on the base of the flash tube
with the red dot in the Tube Socket (4). Push the
flash tube in until it is securely seated into the
socket.
Connecting to a Power Pack
1. Make sure that power pack is OFF before
connecting.
2. Plug one end of Power Cable into Power Socket
(6) of the flash unit, and insert the other end into
the output socket of the power pack.
3. Turn power pack on .
The flash unit is not powered by itself, but draws power from Cheetah Lithium Battery or
Cheetah Ni-MH Battery (sold separately).
For the instructions of the power pack, see the related user manual.
C
onnecting the Flash to a Camera
1. Loosen the locking ring on the mounting foot.
2. Slip the mounting foot of the flash unit into the
camera hotshoe.
3. Secure the flash unit by rotating the locking ring
in the direction of the arrow.
Using the Flash
1. Power Management
ON/OFF Power Switch (19) controls the on-and-off of the flash unit. Turn off the
power pack if the flash unit will not be used for an extended period of time.
1/1
1/1-0.3
1/1-0.7
1/2
1/2-0.3
1/2-0.7
1/4
…
OF
1/2+0.7 1/2+0.3
1/4+0.7 1/4+0.3
…
2. Flash Output
Flash output can be varied from 1/128th power to 1/1 full power in 1/3 stop
increments. To obtain a correct flash exposure, use a hand-held flash meter to
determine the required flash output.
Adjust the power output by rotating Select Dial (21). The following table makes it
easier to see how the stop changes in terms of f/stop when you increase or
decrease the flash output:
Figures displayed when reducing flash output level
→
←Figures displayed when increasing flash output level
