CHEE SIANG INDUSTRIAL GOLDEN WHEEL CS-2390, Инструкция по эксплуатации

Страница: 11 / 12

10
5.
5. 5.
5.運行至最低點時的機針差動調節
運行至最低點時的機針差動調節 運行至最低點時的機針差動調節
運行至最低點時的機針差動調節 ADJUSTMENT OF NEEDLE TIMING AT ITS LOW
ADJUSTMENT OF NEEDLE TIMING AT ITS LOW ADJUSTMENT OF NEEDLE TIMING AT ITS LOW
ADJUSTMENT OF NEEDLE TIMING AT ITS LOWEST POSITION
EST POSITION EST POSITION
EST POSITION
移開面蓋，鬆開針棒座上的螺絲。慢速轉動手
輪直到針棒(F)和針棒搖桿曲桿上的螺絲平
行。此點即為機針最低落點。(Fig.13)
Remove face plate and loosen the screw of
needle bar bracket. Turn the hand wheel slowly
towards you until the needle bar is aligned with
the screw of needle bar crank rod. This is
considered the lowest position of needle.(Fig.13)
6.
6. 6.
6.機針和旋梭差動調節
機針和旋梭差動調節 機針和旋梭差動調節
機針和旋梭差動調節(
((
(使用
使用 使用
使用 DP*17
DP*17 DP*17
DP*17 號機針
號機針 號機針
號機針)
))
)
ADJUSTMENT OF TIMING BETWEEN NEEDLE AND HOOK (Needle being used is
ADJUSTMENT OF TIMING BETWEEN NEEDLE AND HOOK (Needle being used is ADJUSTMENT OF TIMING BETWEEN NEEDLE AND HOOK (Needle being used is
ADJUSTMENT OF TIMING BETWEEN NEEDLE AND HOOK (Needle being used is type DP*17)
type DP*17) type DP*17)
type DP*17)
1.將人字調節鈕調至最大人字寬度 9mm,並使機針
上下運行ㄧ個來回。
Turn the zigzag dial right to the largest width of
9mm and have the needle reach at its rightist and
lowest point.
2.調整旋梭使得旋梭尾部位於機針(L)右側
0.5mm。(Fig.14)
Then set the hook so that the end of hook gib
comes 05mm right of needle (L). (Fig.14)
3.轉動手輪，使旋梭運行至最左，最低點，使得
旋梭尖位於機針穿線孔上側 1mm 。(Fig.15)
Turn the hand wheel to the leftist and lowest
position. See that the hook point travels 1mm
above the thread hole of the needle. (Fig.15)
4.縫制不同物料時，差動太大可能造成一定的遲
延。
When sewing the different materials, it is
recommended that the timing explained above is a
little delayed.
GOLDEN WHEEL