Customer Replaceable Parts
Smart-1 Hardware
Page 32
Action
Press
Confirm the change
Enter
when the cursor is located on the last digit
Cancel the IP change
Esc
when the cursor is located on the first digit
Change current digit
or
Hard Disk drives
The Smart-1 25 appliance contains two 3-1/2", hot-swappable hard disk drives (RAID 1). This lets you do
RAID 1 mirroring across the drives using a dedicated LSI Logic RAID controller.
Customer Replaceable Parts
The Smart-1 25 appliance contains these customer replaceable parts:
Two power supplies
Two hard disk drives
The Check Point warranty and support agreements do not let you replace parts unless told to do so by a
technical support representative. Do not open the Smart-1 case.
Power Supply
This section presents the procedures for removing and installing a power supply unit. The Smart-1 appliance
contains two redundant power supplies. It is not necessary to power off the appliance before adding or
removing a power supply.
Removing the Power Supply
To remove a power supply unit:
1. If the power supply alarm sounds, press the red alarm button to the right of the power supply. This will
stop the alarm.
2. Remove the power cord.
3. Loosen the retaining screw located above the power socket.
4. Pull the extraction handle to remove the power supply unit.
Note
- Use only the extraction handle to remove the power supply unit. To
prevent damaging the power supply, do not pull on the retaining screw,
power cord clip or any other part of the unit.
Installing the Power Supply
To install a replacement power supply:
1. Insert the power supply into its slot and push firmly until it clicks into place.
2. Tighten the retaining screws.
3. Insert the power cord.
