Check Point L-71, Руководство администратора

Страница: 35 / 124

SmartProvisioning
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 35
4. Select an override profile setting:
• Allowed
• Denied
• Mandatory
For more information about override profile settings, see Configuring Profile Settings (on page
36 ).
5. Select
RADIUS is activated on device
to enable RADIUS on the Check Point Appliance.
6. Click Add to add RADIUS servers that were defined in SmartDashboard, select a RADIUS
server from the list and click OK .
7. To remove a server, select a server in the list and click Remove .
8. Use
Up
and
Down
to set the priority to contact RADIUS servers.
9. Click
Allow administrators from specific RADIUS groups only (comma separated)
to allow
authentication from specified groups as defined on the RADIUS server. Only administrators
that belong to those groups can get access.
10. Click
OK
.
Configuring Hotspot
To configure hotspot settings on a Provisioning Profile:
1. Open the
Security Gateway Profile
window, and select the
Hotspot
tab.
2. Select
Manage Hotspot settings centrally from this application
.
3. Click Advanced . The Profile Settings window is displayed.
4. Select one of these override profile settings:
• Allowed
• Denied
• Mandatory
For more information about override profile settings, see Configuring Profile Settings (on page
36 ).
5. Select Hotspot is activated on device to activate the hotspot.
6. Configure the fields:
• Portal Title
- Keep the default or enter a different title.
• Portal message
- Keep the default or enter a different message.
• Terms of use - Select this checkbox to add an "I agree with the following terms and
conditions" checkbox on the Hotspot portal page. Enter the terms and conditions text in the
text box. When users click the "terms and conditions" link, the entered text is shown.
• Require Authentication - To require user authentication, select the checkbox.
• Allow users from specific group
- Select to allow access to a specific user group and not
all users. Enter the group's name in the text box.
7. Click
Apply
.