Checchi & Magli WOLF, Руководство по эксплуатации и обслуживанию

Страница: 71 / 184

UN41 0098BM
A
A
B
D
F
E
E
C
C
C
E
English language Use and maintenance
31
INFORMATION CONCERNING REPLACEMENTS
8
When replacing worn or damaged parts, original
spares must always be used.
Special maintenance operations (non included in
this handbook) require a specialised workshop on the premises which meets the requirements speci-
fied by the relative laws in force (appropriate equip-
ment suitably trained staff etc.); if you do not have a
compliant workshop, contact an authorised one.
Changing and replacing the drilling cups
The dispenser can have up to six drilling cups fitted on
it.
In the set-up with one or two drilling cups, you will need
to fit the phasing units to ensure dispenser integrity (see
“Drilling cups arrangement” - page 5).
Caution
To prevent damage to the transplant unit transmis-
sion, use the driving wheel to rotate the dispenser.
Proceed as outlined below.
1) Lift the work vehicle off the ground.
2) Unscrew the screws (
A ).
3) Remove the mobile guard ( B ).
4) Unscrew the screws ( C ) on each drilling cup ( D ) and
remove it.
Set up the drilling cup control disk and any phasing
units required (see “Drilling cups arrangement”).
5) Fit the cups in the housings.
6) Tighten the screws (
C ) on each drilling cup.
7) If necessary, fit the phasing unit/s (
F
).
8) Tighten the screws ( E ) on each phasing unit.
9) Fit the casing (
B
) and tighten the screws (
A
).
10) Lower the work vehicle onto the ground.