3.7
RESISTANCE MEASUREMENT
Ω
Warning :
Before making a resistance measurement, make sure that the circuit is
cold and any capacitors have been discharged.
1.
Set the switch to
and press the
key. The
Ω
symbol is
displayed;
2.
Connect the black lead to the
COM
terminal and the red lead to «
+
»;
3.
Place the test probes or the crocodile clips on the terminals of the
circuit or component to be measured ;
The measured value is displayed on the screen
Remark :
to measure low resistance values, first carry out the compensation of the
resistance of the leads (see §
3.8
DIODE TEST
Warning:
Before performing the diode test, make sure that the circuit is cold and
any capacitors have been discharged.
1.
Set the switch to
and press the
key twice. The
symbol
is displayed.
2.
Connect the black lead to the COM terminal and the red lead to «+».
3.
Place the test probes or the crocodile clips on the terminals of the
component to be tested.
Содержание CA-F201
Страница 1: ...F201 Clamp multimeter GB User s manual...
Страница 36: ...692882A02 Ed 7 07 2016...
