Chauvin Arnoux CA-F201, Руководство пользователя

Страница: 16 / 36

3 USE
3.1 COMMISSIONING
Insert the battery supplied with the device as follows:
1. Using a screwdriver, unscrew the screw of the battery compartment cover
(item 1) on the back of the housing and open it.
2. Place the battery in the compartment (item 2), taking care to get the
polarities right.
3. Close the battery compartment cover and screw it to the housing.
Figure 6 : the battery compartment cover
3.2 STARTING UP THE CLAMP MULTIMETER
The switch is set to OFF. Turn the switch to the function of your choice. The whole
display lights (all symbols) for a few seconds (see §
1.3 ), then the screen of the
function chosen is displayed. The clamp multimeter is then ready to make
measurements.
3.3 SWITCHING THE CLAMP MULTIMETER
The clamp multimeter can be switched off either manually, by setting the switch to
OFF, or automatically, after ten minutes with no action on the switch and/or the
keys. Thirty (30) seconds before the device is switched off, an audible signal
sounds intermittently. To re-activate the device, press any key or turn the switch.
1
2