Chauvet Rogue R3 Spot, Руководство пользователя

Страница: 9 / 30

Page 6 of 27
Rogue R3 Spot User Manual Rev. 1
S
ETUP
4. S
ETUP
AC Power
Each Rogue R3 Spot has an auto-ranging power supply that works with an input voltage range of 100 to
240 VAC, 50/60 Hz. To determine the power requirements for each Rogue R3 Spot, refer to the label
affixed to the product. You can also refer to the Technical Specifications chart in this manual.
The listed current rating indicates the maximum current draw during normal operation. For more
information, download Sizing Circuit Breakers from the Chauvet website: www.chauvetprofessional.com .
.
AC Plug
The Rogue R3 Spot comes with a power input cord terminated with a Neutrik® powerCON® connector on
one end and an Edison plug on the other end (U.S. market). If the power input cord that came with your
product has no plug, or if you need the change the plug, use the table below to wire the new plug.
Fuse Replacement
1. Disconnect this product from the power outlet.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse and replace with a another fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
Power Linking
The product supports power linking. You can power link up to 3 products at 120 V; up to 5 at 208 V; or up
to 6 at 230 V.
This product comes with a power input cord. Power linking cables are available from Chauvet for
purchase.
DMX Linking
You can link the Rogue R3 Spot to a DMX controller using a 3- or 5-pin DMX connection. If using other
DMX-compatible products with this product, you can control each individually with a single DMX controller.
DMX Personalities
The Rogue R3 Spot uses a 3- or 5-pin DMX data connection for its 19-channel or 25-channel DMX
personalities.
• Refer to the Introduction for a brief description of each DMX personality.
• Refer to the Operation chapter to learn how to configure the Rogue R3 Spot to work in these
personalities.
• The DMX Values section provides detailed information regarding the DMX personalities.
• Always connect the product to a protected circuit (circuit breaker or fuse). Make
sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
• To eliminate unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by unplugging
it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.
Connection Wire (U.S.) Wire (Europe) Screw Color
AC Live Black Brown Yellow or Brass
AC Neutral White Blue Silver
AC Ground Green/Yellow Green/Yellow Green
!