Chauvet MAVERICK MK3 PROFILE, Руководство пользователя, Страница: 27 / 37

Page 23 of 33
Maverick MK3 Profile User Manual Rev. 2
Operation
WDMX Reset
To reset the WDMX connection and allow the Maverick MK3 Profile to connect to a WDMX transmitter:
1. Go to the Settings main level.
2. Select the WDMX Reset option.
3. Select from NO (do not reset), or YES (reset the WDMX connection).
Display Backlight Timer
To set the length of time before an inactive display will turn off:
1. Go to the Settings main level.
2. Select the Backlight Timer option.
3. Select the length of the backlight timer, from 30S (30 seconds), 1M (1 minute), 5M (5 minutes), or
ON (always on).
Loss of Data
To set how the product reacts to a loss in control signal data:
1. Go to the Settings main level.
2. Select the Los of Data option.
3. Select from Hold (holds the last values received before signal loss), or Close (blacks out the
product).
Fan Mode
To set the fan speed mode:
1. Go to the Settings main level.
2. Select the Fans option.
3. Select the fan mode, from Auto (fan speed adjusts to product temperature), Full (fan speed at
maximum), or ECO (quiet mode).
Dimmer Curve
To set the dimmer curve:
1. Go to the Settings main level.
2. Select the Dimmer Curve option.
3. Select the dimmer curve, from Linear , Square , I Squa , or SCurve .
Pulse Width Modulation
To adjust the frequency of the pulse width modulation:
1. Go to the Settings main level.
2. Select the PWM Option option.
3. Select the frequency, from 600Hz , 1200Hz , 2000Hz , 4000Hz , 6000Hz , or 15000Hz .
Preset Selection
To select a preset configuration of menu options:
1. Go to the Settings main level.
2. Select the Preset Select option.
3. Select from PRESET A (default), PRESET B , or PRESET C .
Preset Synchronization
To transfer saved Presets from one Maverick MK3 Profile to another:
1. Connect the Maverick MK3 Profile products to receive the Presets by a DMX daisy chain.
2. Make the Maverick MK3 Profile with the Presets to transfer the first in the DMX daisy chain.
3. Power on all of the products.
4. Set all of the products to a Control Mode other than WDMX . ( DMX , ArtNet , or sACN )
5. On the Maverick MK3 Profile with the Presets, go to the Settings main level.
6. Select the Preset Sync option.
7. Select NO (to cancel) or YES (to transfer the Presets to the connected products).
Follow instructions in the manual or guide for the WDMX controller being used to connect
it to the receiver in the Maverick MK3 Profile.
• Changes to settings automatically save to the currently selected Preset.
• If no Preset has been selected, changes to settings save to PRESET A.
• After selecting a Preset, the product will restart.
• All menu configurations are transferred except for the IP address.
• ONLY connect Maverick MK3 Profile products for this function!