Page 5 of 13
Hurricane 2000 User Manual Rev. 2
S
ETUP
3. S
ETUP
AC Power
The Hurricane 2000 has a auto-ranging voltage power supply and it can work with an input voltage of
either 120 VAC, 60 Hz or 230 VAC, 50 Hz, depending on the specific model.
To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current
value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart.
The listed current rating indicates the product’s average current draw under normal conditions.
Resetting the Breaker
This product is equipped with a resettable circuit breaker. If the breaker trips, all sections of this product will
lose power.
1.
Remove the power cord from mains power.
2.
Allow unit to cool for 15 minutes.
3.
After 15 minutes, you may attempt to reset the breaker by pressing the button with your finger.
4.
Plug the product’s power cord into the power outlet and continue using as recommended.
Mounting
Before mounting the product, read and follow the safety recommendations indicated in the
Orientation
Rigging
•
Before deciding on a location, always make sure there is easy access to the product for
maintenance and fluid replenishment.
•
Make sure adequate ventilation is provided around the product.
•
Make sure that the structure or surface onto which you are mounting the product can support the
product’s weight. (see the
)
•
When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, such as an elevated platform or a truss.
•
When rigging the product onto a truss, you should use a mounting clamp of appropriate weight
capacity. The bracket has 13-mm holes, which are appropriate for this purpose.
•
The rubber feet also serve as floor supports and allow for surface mounting. When mounting the
product on the floor, make sure that the product and cables are away from people and vehicles.
•
Always connect the product to a protected circuit (a circuit breaker or fuse).
Make sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by
unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.
Disconnect the product from the power outlet before resetting the breaker.
This product may NOT be tilted. This product should be level when on a surface or
when mounted.
Содержание Hurricane 2000
Страница 1: ...User Manual ...
