Chattanooga Saunders, Руководство пользователя

Страница: 10 / 44

10 / 43 ENGLISH
When the treatment is complete, release the traction by rotating the gauge housing
to the “RELEASE” position Slacken the belts and release the buckles You should
relax for a few minutes then slowly move your pelvis from side to side before
getting out of the device
The Saunders Lumbar Traction device will return to the starting position once you
have moved off the device
NOTE: In the course of your treatment it is normal for a small loss of pressure (by 10%)
due to the relaxation of your spine. As this occurs, add additional air to return to
the prescribed force. If you give too much traction, rotate the gauge housing to the
“RELEASE” position to let some air out of the system.
REVIEW OF HAND PUMP OPERATION
1 “HOLD” – holds traction force at the desired level
2 “PUMP” – fills the cylinder with air, increasing the traction force
3 “RELEASE” – empties air from the cylinder during or after treatment and prior to use
MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE
If you believe your Saunders at home Lumbar Traction device requires maintenance
or repair please contact the following:
For usa product support please call 1-800-494-3395, or visit chattanoogarehab com
For international product support please contact your local dealer, or your
corresponding DJO Global site
You may also contact us internationally at the below email address:
internationalproductsupport@DJOglobal com