DEVICE ISSUES
26
HOW TO PAIR A MODULE
If there are issues about the pair of one module follow the steps described below:
1.
Switch off the module. Then push and maintain pushed the On/Off button of the module for 20 seconds, during
this time the button blinks red and green (in order to “reset” the module).
2.
After 20 seconds, the module’s LED switches off.
3.
Verify that the module’s LED is switched off and then release the On/Off button.
4.
At this stage, the module is switched off.
5.
Switch on your remote control and go in the “Settings” menu.
6.
In the “Settings” menu go down and select the “Pair a new module”.
7.
Now you can switch on the module.
8.
If the module is recognized by the remote control the module LED becomes green and a small green circle should
be displayed at the top of the display.
CHARGING AND POWERING ON PROBLEMS
There are always two ways of knowing if a module is fully charged.
1.
The guide lights on the docking station indicate the charge status of the modules.
2.
Before launching an electrostimulation session, on the remote control screen, there are icons which indicate the
state of charge of every operating module (figure below).
Figure 8 : Before (left) and after (right) the pairing of the module
Note: Final accessories may differ from the picture
Figure 9 : State of charge of the modules - case 1 (left) & case 2 (right)
Note: Final accessories may differ from the picture
