41
Mobile 2 RPW User Manual
• Now take out of the overhaul kit the new sealing rings for the shock transmitters and
for the shaft and install them. Observe the O-ring Guide for this purpose. It is contained
in the overhaul kit.
• Take out the new guide tube and the new projectile from the overhaul kit.
11
• Insert the guide tube into the opening in the shaft by pressing it until it hits the stop.
• Make sure that the end of the guide tube where the two air slots are located is in the
direction of the handpiece handle.
12
• Insert the new projectile into the fitted guide tube.
13
• Mount the new sealing ring from the overhaul kit onto the shaft.
• Screw the shaft into the handpiece until finger-tight.
• Hold the handpiece firmly on the table with one hand and tighten the shaft with the
open-end spanner. It must no longer be possible to unscrew the shaft by hand.
14
