13
Mobile 2 RPW User Manual
3. Operation
3.1 GENERAL WARNINGS AND SAFETY INFORMATION
CAUTION
The device is intended exclusively for use by medical specialists and may only be used by such suitably
qualified and trained medical personnel (see chapter 1.3 PREREQUISITES FOR OPERATING THE DEVICE).
The user is responsible for correctly positioning the handpieces of the device.
Correct determination of the location of the treatment zone is the responsibility of the user.
Only perform treatments approved by the manufacturer!
To avoid safety hazards, use of the instrument for applications other than those specified in chapter 1.1.1
INDICATIONS is not allowed!
The device has a potential equalisation connection. This must be connected in accordance with the relevant
national regulations.
Do not use the device in potentially explosive environments, i.e. in the presence of a flammable anaesthetic
mixture with air or with oxygen or nitrous oxide.
If instruments are connected that are not medical products as defined by EN IEC 60601, they must be set up
outside the vicinity of the patient.
Cleaning agents and disinfectants can form an explosive atmosphere. Disconnect the device from the mains
before starting any cleaning or maintenance work!
Before any cleaning and maintenance work on the handpiece, disconnect the handpiece plug from the
handpiece connection! Do not connect the handpiece until it has been completely reassembled!
CAUTION
Do not try to open the instrument! Risk of electric shocks!
Risk of transmission of microorganisms! Disinfect the handpiece after each treatment!
Also refer to chapter 4 CLEANING, MAINTENANCE, OVERHAUL for details.
ATTENTION
Check that the installation surfaces have sufficient carrying capacity to avoid equipment damage!
Portable and mobile HF communications equipment (e.g. mobile phones) can interfere with electrical equipment.
The use of accessories or cabling not authorised by the manufacturer may cause increased emissions or may lead to reduced
interference resistance of the device.
The device must neither be deployed nor stored together with other devices. If the operation near or jointly with other devices
is required, the device must be must be tested in that particular environment to ensure operation according to technical
specification. The device may be positioned and operated near the listed accessories.
The instrument must only be connected to properly earthed and correctly installed shockproof sockets!
Check that the instrument is in perfect working order before each use (see chapter 3.3 FUNCTIONAL CHECKS).
Never cover the instruments when in use!
Make absolutely sure that no liquid can seep into the system housing or handpiece.
Any damage to the instrument resulting from incorrect operation is not covered by the manufacturer’s warranty.
Disposal of the instrument and its components must be carried out in accordance with national waste disposal regulations.
The device must only be used with accessories that have been approved by the system manufacturer. To prevent safety hazards,
unauthorized system modifications are not allowed. This will void the CE mark approval and warranty.
