Chattanooga Group FLUIDC DHT 1480, Руководство по обслуживанию

Страница: 20 / 49

Fluido DHT
™
Dry Heat Therapy Unit
18
REMOVAL & REPLACEMENT
C C.. R Reeppllaacciinngg tthhee FFlluuiiddoo H Heeaatteerr
N NO OTTEE:: Before attempting to replace the Fluido
heater, Vacuum any loose Cellex that may
be in the motor housing or heater
housing.
To replace the Fluido heater, reverse steps 1 through
21 of “Removing the Fluido Heater” on pages 15-17
(i.e., instead of cutting wires, simply solder or
reattach them).
N
NO OTTEE:: When replacing the Fluido heater, be sure
to use a new diffuser (14119).
FFlluuiiddoo D Diiffffuusseerr
A A.. TToooollss R Reeqquuiirreedd
Wet/Dry Vacuum #2 Phillips Screwdriver
Wire Cutters 7/16 Wrench
B B.. R Reem moovviinngg tthhee FFlluuiiddoo D Diiffffuusseerr
To remove the Fluido diffuser, following steps 1 - 13
of “Removing the Fluido Heater” on pages 15-16.
C C.. R Reeppllaacciinngg tthhee FFlluuiiddoo D Diiffffuusseerr
To replace the Fluido diffuser, reverse steps 1 through
13 of “Removing the Fluido Heater” on pages 15-16.
FFlluuiiddoo M Moottoorr
A A.. TToooollss R Reeqquuiirreedd
#2 Screwdriver
B B.. R Reem moovviinngg tthhee FFlluuiiddoo M Moottoorr
Before attempting to remove the Fluido motor, you
must complete steps 1 through 3 of “Removing the
Muffler and Muffler Cover” on page 19.
1. Remove the five screws outside of the motor
support plate, being sure to hold the plate while
removing the last screw.
2. With one hand, hold the motor while using your
other hand to disconnect the motor wiring from the
harness. See the following 2 figures.
!
CAUTION
Be careful not to damage the metal shaft on the end of
the motor. See the following figure.
!
CAUTION
Hold the motor support plate before removing the last
screw. Otherwise, the motor may fall from the housing.