Megabeat Pro
Megabeat Pro
How using the ”CLICK” function
By the CLICK function, you can send an analog audio signal to a musician (usually a drummer
or anybody else who needs a rhythmic reference) thru the CLICK output port (¼ inch
stereo standard jack) located on Megabeat Pro’s rear panel.
Talking about MIDIfiles, the click signal will be automatically generated by the system
and, once all the related parameters will be set, no further operations are required.
Notes:
_ By enabling the CLICK mode, the PRELOAD function will be disabled and so all LINK
modes.
_ The CLICK function will work fine only if correctly programmed. It means you will have
to insert it according to the MIDIfile’s rhythmic informations (please find you could
encounter, even if very seldom actually, some MIDIfiles programmed incorrectly where
music and rhythmic informations are not synchronized between them)
_You can get the click signal thru the CLICK stereo output located on Megabeat Pro’s rear
panel
PROGRAMMABLE PARAMETERS
To enter the CLICK function programmable parameters, select UTILITY/MIDI SETUP
page, then “MIDI CLOCK OUT” function. Now, by pressing the “CHANGE” key or rotating
the “PAGE/VALUE” alpha-dial, you can choose among the following options:
DISABLED : MIDI clock and audio click both disabled.
MIDI : MIDI clock enabled (better in “USER” mode) audio click disabled
CLICK : Audio click enabled
MIDI SETUP
MIDI CLOCK OUT CLICK
RESET TYPE
GS RESET
MIDI SONG SEL FILTERED
VOCALIZER INPUT SONG
LYRICS SYLLAB.
ENABLED
VOLUME TYPE
GM SYSEX
SC88ST MODE
DOUBLE
PRELOAD ENABLED
SAVE |CLICK | CHANGE | | EXIT
1
