4
4
CHARIOT CARRIER CTS READY
CHARIOT CARRIER CTS READY
CHASSIS
CHASSIS
ASSEMBL
ASSEMBL
Y
Y
Your Chariot Carrier is shipped 99% assembled.
Initial assembly takes a few minutes. After that,
folding and unfolding can be done in seconds.
Stand at the back of the carrier body. Grab
the upper frame and pull up until it stops.
CAUTION: Pull back on the lower bars
from under the pivot brackets to avoid
pinching your fingers.
1.1 Wheel Assembly
Pull back on both the right and left lower
backtube bars until they “snap” all the way
back over center and the auto-lock disks
engage.
WARNING: Ensure that folding brackets
are correctly locked before using carrier.
Failure to do so could cause the carrier
to collapse.
To collapse the carrier, pull the release
disks and then push both the right and left
lower backtube bars forward until the
carrier is completely collapsed.
CAUTION: Do not attempt to collapse
carrier without first pulling the release
disks.
1.
Depress the rubber cap on the wheel hub with your thumb and fully insert the clevis axle into the hollow axle. CX carriers have the brake
located at the end of the axle, with the hollow axle located in the centre of the brake. Once fully inserted and secured, you should hear a
“click” sound.
Important:
To ensure the axle system is engaged properly, test by trying to pull the wheel outwards after installing. The wheel
should be locked in its installed position. If not, do not use and take your carrier to your Chariot Dealer for servicing.
2.
Repeat all steps for the
other wheel.
CLEVIS AXLE
1.0 Folding and Unfolding the Carrier
NOTE:
Any reference to orientation (left or right) is from the passengers point of view while in the carrier.
HOLLOW AXLE
