background image

5

GENERAL OPERATION

Use charger for charging a LEAD-ACID (lead acid,
sealed lead acid, gel cell and AGM) battery only. It is not

intended to supply power to a low voltage electrical system other than in a
starter-motor application. Do not use battery charger for charging dry-cell
batteries that are commonly used with home appliances. These batteries
may burst and cause injury to persons and damage to property.

DO NOT attempt to attach a charger to a battery pack if
the output of the charger does not match the battery

pack voltage. Example: Model i-3612 is a 36 volt output charger and is only
usable on 36 volt battery systems. Charger and battery damage can occur.

Be extra cautious to reduce risk of dropping a metal
tool onto battery. It might spark or short-circuit battery

or other electrical part that may cause an explosion. If damaged contact
Charging Systems International.

NEVER charge a frozen battery.

Assure that your charger and batteries are properly vented. Connect your
extension cord, with no AC Power present, to the battery charger and proceed to
plug your extension cord in at a nearby 120VAC GFCI protected (Ground Fault
Circuit Interrupt) outlet.

Risk of electrical shock! Do not touch uninstalled parts
of the battery charger output connector, battery

connector, or battery terminals.

Once you plug in your Charging Systems International battery charging system,
the charge cycle will begin automatically. State of charge will be displayed by
illumination of the LED's on the battery status indicator located on the front of the
unit.

DO NOT disconnect the DC output electrical cord from
the battery receptacle when the charger is on. The

resulting arcing and burning of the plug and receptacle could cause the
batteries to explode. If the charger must be stopped, first disconnect the
AC power supply cord from its outlet, then disconnect the charger DC
output plug from the battery receptacle.

We recommend that you leave your system plugged in to reduce sulfate build-up
and to allow your Charging Systems International charging system to keep your
batteries fully maintained and ready to perform at their best.

DANGER

CAUTION

WARNING

WARNING

WARNING

WARNING

Содержание i-2412









Отзывы: