3
CH-20
INTRODUCTION (continued)
Remote Control Keys
1. Standby –
To let you place the TV set on standby. To turn on the TV, press .
2. Number keys –
Direct access to the programs. For a 2 digit program, enter
the 2nd digit before the dash disappears.
3. Menu –
To call up or exit the menus.
4. Cursor –
These 4 keys are used to move around the menus.
5. Program selection –
To access the next or previous program. The number,
(name) are displayed for a few moments.
Volume adjust –
To adjust the sound level.
6. Pre-set image –
Used to access a series of stored settings:
Soft, Natural,
Rich
and return to
Personal
.
7. Recall –
To return to the last channel viewed.
8. Pre-set sound –
Used to access a series of stored settings:
Speech, Theater,
Music
and return to
Personal
.
9.
TV/Video –
To toggle between TV and different Video modes.
10.Mute –
To mute or restore the sound.
11.Sleep –
To select an automatic standby after a preset time (from 0 to 240
minutes).
12.Screen information –
To display/clear the program number, name (if any),
time, etc. This key is also used to exit from the menu. When there is no signal
received,
“
No signal
”
will be displayed on the screen.
13.Zoom –
Press this key repeatedly to switch the TV among the
16:9, Zoom
and
4:3
modes.
14.Sound mode –
(Only available on certain versions)
Used to force programmes in
Stereo
to
Mono
or, for bilingual programs, to
choose between
Dual I
or
Dual II
. For TV sets equipped for Nicam reception,
depending on the programmes, you can force the
Nicam Stereo
sound to
Mono
or select between
Nicam Dual I
,
Nicam Dual II
and
Mono
. In the Video
mode, “
Stereo
” is default setting, and pressing this key can force
Stereo
to
Left
or
Right
.
15.Surround –
(Only available on certain versions)
To activate/disable the
incredible surround feature. In mono, a pseudo spatial stereo effect is obtained.
In stereo, the speakers appear further apart.
(Only available on certain versions)
To select Mono/Surround in the TV mode
and select Stereo/Surround in the Video mode.
16.Teletext (P9)
Notes:
1) When in operation, please point your remote control directly to the infrared sensor. If the sensor receives remote signal,
the power indicator blinks.
2) Do not expose the remote control to impacts, water or disassemble it.