100535 - 27 IN. 2-STAGE SNOWBLOWER
ASSEMBLY
14
ASSEMBLY
Your snowblower requires some assembly. This unit ships from
our factory with oil. It must be properly serviced with fuel and oil
before operation.
If you have any questions regarding the assembly of your
snowblower, call our Technical Support Team at 1-877-338-0999.
Please have your serial number and model number available.
Unpacking
1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the snowblower
base — including upper and lower handles, connecting
levers, chute, hardware, etc. Make sure all the assembly
parts are included before you start.
3. Lift the top half of the box off and the base should be clear to
start assembly.
4. Cut down the bottom carton to allow a flat surface area to
install the assembly parts without scratching parts or cutting
tires. Alternatively, with team lift help, lift the base of the
snowblower out of the carton and place it on a flattened
carton to start assembly.
Handle
1. Attach the lower handle (1-1) onto the unit body with
4 self-tapping bolts (1-2) using included tool or your own
13mm wrench (Fig. 1).
1–1
1–2
Figure 1
2. Connect the upper and lower handle with bolts (2-1), washers
(2-2) and locking knobs (2-3) (Fig. 2). The top handle can
adjust to 4 positions. You can come back later and adjust to a
more comfortable height.
2–1
2–3
2–2
Figure 2
3. Remove the chute pivot assembly (3-1) from the bubble wrap
and attach to the bracket on the chute (3-2). Align the round
and square connector on the underside of the chute pivot
assembly to the bracket. The square connector snaps in
place. Then, place the entire chute (3-3) over the two posts
(3-4) aligning the chute with the base (3-5). The chute will
just rest on the base and rotate at this point (Fig. 3).
3–1
3–2
3–4
3–3
3–5
Figure 3
