Carton Inventory
Overview
The Ultra RX - Extreme Range Receiver has a
10-24Vac/Vdc operation with low power consumption
(150 ua). The Receiver has 4 Channels, 2 Transistors
and 2 Relays. The Receiver can control up to
4 devices.
1
Receiver
Model ULTRX900R
Ultra RX - Extreme Range Receiver
Setup
1 3
2
4 5 6 7 8 9 10
11
12 13
10-24 Vac
1 3
2
4 5 6 7 8 9 10
11
12 13
-
+
10-24 Vdc
NOTE:
Polarity does not matter.
Power Connections
Relay Outputs
The Receiver has 2 Relays and 2 Transistor (Open
Collector) Outputs to control up to 4 devices.
Higher Amperage (10 amp) applications that are
directly controlled, should use Relay Channels 1
and 2.
Relay 1:
11:
Common
12:
Ch 1 Normal Open
13:
Ch 1 Normal Closed
1 3
2
4 5 6 7 8 9 10
11
12 13
Relay 2:
8:
Common
9:
Ch 2 Normal Open
10:
Ch 2 Normal Closed
Lower Amperage (500 ma or lower) applications that
are indirectly controlled, should use Transistor Output
Channels 3 and 4.
Channel 3:
Terminal 6
Channel 4:
Terminal 4
1 3
2
4 5 6 7 8 9 10
11
12 13
1 3
2
4 5 6 7 8 9 10
11
12 13
1 3
2
4 5 6 7 8 9 10
11
12 13
Dipswitch Settings
NOTE:
If using the Receiver with a Gate Control Unit
(GCU) proceed to
Program with Gate Control Unit
(GCU)
.
NOTE:
The Dipswitches on the
Receiver can be accessed by
removing the screw on the
bottom of the Receiver.
Ensure the Receiver does
not have power. Set
Dipswitch #1 to the ON
position.
NOTE:
These steps apply only if more than one
Receiver is being used.
Step 1:
Ensure the
Receiver does not have
power. Set Dipswitch #1 to
the ON position in each
Receiver.
Step 2:
Set the Identity of each additional Receiver
by changing the Dipswitches as shown in the chart
below.
Receiver ID
Switch #2
Switch #3
2
ON
OFF
3
OFF
ON
4
ON
ON
Additional Receivers
NOTE:
Do not connect power until instructed to do so.
