Chamberlain Motorlift ML700, Инструкция по эксплуатации

Страница: 36 / 142

en
11
Specifications
Input Voltage...................230-240 VAC, 50 Hz
Max. Pull Force ..............700 N (ML700, ML750), 800 N (ML850)
Power .............................115 W (ML700, ML750), 125 W (ML850)
Standby Power ...............2.6 W (ML700, ML750), 2.8 W (ML850)
Normal Torque ................7 Nm (ML700, ML750), 8 Nm (ML850)
Motor
Type................................DC gearmotor permanent lubrication
Noise level......................55dB
Drive Mechanism
Drive ...............................Chain/belt with two-piece trolley on steel rail.
Length of Travel..............Adjustable
Travel Rate .....................127-178 mm per second
Lamp...............................On when door starts, off 2-1/2 minutes
after stop.
Door Linkage ..................Adjustable door arm. Pull cord trolley release.
Safety
Personal .........................Push button and automatic stop in down
direction. Push button and automatic stop in
up direction.
Electronic........................Automatic force adjustment
Electrical .........................Transformer overload protector and low
voltage push button wiring.
Limit Device ....................Optical RPM/Passpoint detector.
Limit Adjustment .............Electronic, Semi and Fully Automatic.
Start Circuit .....................Low voltage push button circuit.
Dimensions
Length (Overall)..............3.2 m
Headroom Required .......32 mm
Hanging Weight ..............12 kg
Receiver
Memory Registers ..........12
Operating Frequency......433.92MHz
SPECIAL NOTE: Chamberlain strongly recommends that the protector
system be installed on all garage door openers.
Spare parts
34
35
16. The door releases by itself from the carriage and stops:
• An external release that has been installed during a power failure
should be checked whether it stretches and releases during the
opening of the door. Watch the mechanism and reset if necessary.
• The handle of the release mechanism should not get caught in other
items.
17. The running path cannot be programmed, is de-programmed
or is changing slowly:
• The programmed running path is too short. Programme a longer path
for testing purposes (+120 cm).
• A mechanical fault at the door due to deflected joints or the chain
tension on the drive is too loose.