1
RESET SWITCH
MODEL K71-33445
FOR USE WITH OMNI BOARD
UPGRADE FOR CSW200
AND SL3000
To prevent possible SERIOUS INJURY or DEATH from
electrocution, disconnect electric power to operator BEFORE
installing.
ALL electrical connections MUST be made by a qualified
individual.
CARTON INVENTORY
Reset switch bracket, washer head screws (3) #10-32X5/8”,
washer nuts (3) #10-32, reset switch with cable, label, plastic
grommet and cable ties (3).
INSTALLATION
1. Disconnect
power
to
operator.
2. Remove the cover from the operator.
3. Assemble reset switch by installing screws (3) and nuts (3)
to the mounting bracket (Figure 1).
4. Attach the assembly to the operator leg with (3) screws
5. against the top edge and the front flange to the front edge of
the leg (Figure 2).
WARNING:
This product can expose you to chemicals
including lead, which are known to the State of
California to cause cancer or birth defects or other
reproductive harm. For more information go to
www.P65Warnings.ca.gov
2. Remove the cover from the operator.
3. Assemble reset switch by installing screws (3) and nuts (3)
to the mounting bracket (Figure 1).
4. Attach the assembly to the operator leg with (3) screws
against the top edge and the front flange to the front edge of
the leg (Figure 2).
Washer Head Screws
SL3000
Washer Nuts
FIGURE 1
Washer Nuts
CSW200
Washer Head Screws
Wire through this hole if
connected to board.
SL3000
All (3) screws are against the top edge
of the leg then tighten all screws.
This flange is against
the front edge of the leg.
CSW200
Wire through here if not
connected to board.
Other (2) screws are against
the top edge of the leg.
Wire through this hole if
connected to board.
FIGURE 2
