This door control contains a motion
detector which automatically turns your open-
ers light on when it detects a person entering
the garage. This feature may be disabled if
required.
INSTALLATION
The door control is typically attached directly to the wall. However you
may use a single gang wall box if installed.
Note: If installing close to door frames or the switching devices
ensure the detector switch (right side of unit) is accessible.
• Disconnect power to the garage door opener.
• Strip wire insulation approx 6mm and connect
wire with Red trace to the “R” terminal, connect
white non trace wire to the “W” terminal.
• Remove the push bar by gently
prying off the top edge with a
flat blade screwdriver or coin.
• For standard wall mounting,
mark a position on the wall
approximately 20mm above
the desired mounting height of
no less then 1520mm. Partially
fasten the self tapping screw into the wall
leaving around 5mm of thread protruding from
the wall. Slip the lower part of the cover over
screw head and adjust for a snug fit.
Ensure the Wall control is level, then fasten
the top screw through the hole located at the top
of the wall controller. DO NOT OVERTIGHTEN.
Run a figure 8 cable up the wall and across
the ceiling to the opener, using the insulated
staples or surface mount conduit (not provided)
to secure cable into place. Take care not to damage
cable.
Model C198
LCD Motion Detecting Control Panel
OWNERS INSTRUCTIONS
Opener Connections
Ensure the power to the unit is off.
MT60:
Open the light cover at the front of the opener. Direct
the bell wire through the rectangular opening located above
the openers terminals.
Connect the Red/White wire to the 1 terminal then
connect the White wire to the 2 terminal.
MT600/800/1000:
Connect the Red/White wire to the
Red number 1 terminal then connect the White wire to num-
ber 2 terminal located on the back of the opener.
MR600a/800a/MR850:
Remove the diffuser up and away
from the opener to expose the terminals.Connect the
Red/White wire to the Red terminal located on the unit’s con-
trol board then connect the White wire to the White terminal.
MT5580/MT3850:
Connect the Red/White wire to Red
terminal located on the back of the opener then connect the
White wire to the White terminal.
CG3800/CG3800R:
Open the flap located on the front of the
opener to access the terminals. Connect the Red/White wire
to the Red terminal located on the unit’s control board then
connect the White wire to the White terminal.
FOR TERMINAL DETAILS SEE NEXT PAGE
DO NOT CONNECT TO LIVE ELECTRICAL WIRING.
CONNECT ONLY TO 24 VOLT LOW VOLTAGE WIRES.
CONNECTION TO LIVE WIRES OR HIGHER VOLTAGE
MAY CAUSE SERIOUS INJURY FROM SHOCK, BURN
OR ELECTROCUTION.
Children operating or playing with a garage door opener
can injure themselves or others.
The garage door could
close and cause serious injury or death.
Install the door control (or any additional push buttons) out
of the reach of children and away from all moving parts of
the door and door hardware,
but where the garage door is
visible.
Do not allow children to operate the push button(s)
or the remote control transmitter(s).
A moving garage door could injure
someone under it.
Activate the opener only when the door is properly ad-
justed, you can see it clearly, and there are no obstructions
to door travel.
Terminal
Screws
(BACK VIEW)
Top
Mounting
Hole
Bottom
Mounting
Hole
W
2
R
1
Bell
Wire
24 Volt Bell Wire
PRE-WIRED INSTALLATION
(Wall box not provided)
To Replace
Insert Top
Tabs First
Push Bar Cover
Locate the door control within sight of the
door at a height of no less than 1.5m (out of
the reach of children and away from any of
the door’s moving parts and hardware).
