41
DIAGNOSTIC CODE
SYMPTOM
SOLUTION
Up Arrow
Flash(es)
Down Arrow
Flash(es)
4
6
The garage door opener will not close and the light bulbs flash.
Safety reversing sensors are misaligned or were momentarily obstructed. Realign both sensors to ensure both
LEDs are steady and not flickering. Make sure nothing is hanging or mounted on the door that would interrupt the
sensor’s path while closing.
The garage door opener can beep for several reasons:
l
Operating on battery power or the 12 Vdc battery needs to be replaced, see page 32.
l
Garage door opener has been activated through a device or feature such as Timer-to-Close or garage door
monitor, see page 37.
My remote control will not activate the garage door:
l
Verify the lock feature is not activated on the door control.
l
Reprogram the remote control.
l
If the remote control will still not activate the door check the diagnostic codes to ensure the garage door opener
is working properly.
My door will not close and the light bulbs blink on my motor unit:
The safety reversing sensor must be connected and aligned correctly before the garage door opener will move in the
down direction.
l
Verify the safety reversing sensors are properly installed, aligned and free of any obstructions.
My garage door opener light(s) will not turn off when the door is open:
The garage door opener is equipped with a feature that turns the light on when the safety reversing sensors have been
obstructed or when the motion sensor on the door control detects movement in the garage. These features can be
disabled using the door control, see page 36.
Wi-Fi troubleshooting
The garage door opener will NOT enter Wi-Fi LEARN mode:
l
After the initial installation of the garage door opener, the garage door opener must complete a full cycle (open
and closed) before the Wi-Fi LEARN mode can be activated.
l
If there has been a recent power outage, the garage door opener must complete a full cycle before the Wi-Fi
LEARN mode can be activated.
See page 33 to activate Wi-Fi LEARN mode.
If your black adjustment button is not solid green go to wifihelp.chamberlain.com.
My vehicle's Homelink
®
is not programming to my garage door opener:
Compatibility Bridge
TM
(not included) may be necessary for certain vehicles. Visit bridge.chamberlain.com to find out if
a Bridge is needed.
My neighbor’s remote control opens my garage door:
Erase the memory from your garage door opener and reprogram the remote control(s).
Green battery status LED - All systems are normal:
l
A solid green LED light indicates the battery is fully charged.
l
A flashing green LED indicates the battery is being charged.
Orange battery status LED - The garage door opener has lost power and is in battery backup mode:
l
A solid orange LED with beep, sounding approximately every 2 seconds, indicates the garage door opener is
operating on battery power.
l
A flashing orange LED with beep, sounding every 30 seconds, indicates the battery is low.
Red battery status LED - The garage door opener's 12V battery needs to be replaced:
l
A solid red LED with beep, sounding every 30 seconds, indicates the 12V battery will no longer hold a charge and
needs to be replaced. Please call for replacement battery to allow your system to operate during a power outage.
Battery Status LED
Troubleshooting
