1-BUTTON REMOTE CONTROL MODEL 950EV
To prevent possible SERIOUS INJURY or DEATH from a moving gate
or garage door:
• ALWAYS keep remote controls out of reach of children. NEVER
permit children to operate, or play with remote controls.
• Activate gate or door ONLY when it can be seen clearly, is properly
adjusted and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed.
NEVER permit anyone to cross path of moving gate or door.
Your remote control is designed for use with garage door openers
manufactured starting January 1, 1993 that have a LEARN button.
The images throughout this manual are for reference only and your
product may look different.
BEFORE YOU START
Locate the LEARN button on the garage door opener, and then locate the
program button on the remote control.
IMPORTANT:
The remote will activate your door or gate during
programming. Be sure the door is clear of ALL obstructions. Start with the
garage door closed. Make sure the garage door opener has a working light
because it is a programming indicator.
PROGRAM TO GARAGE DOOR OPENERS WITH A
YELLOW LEARN BUTTON
If your remote was previously programmed to another type of opener,
follow the programming instructions for
PROGRAM TO ALL GARAGE
DOOR OPENERS
below to reprogram to a yellow LEARN button.
1.
Start with the garage door closed.
2.
Press and immediately release the yellow LEARN button. The Learn
LED glows steady for 30 seconds. Within 30 seconds...
1.
Press and hold the button on the remote control.
2.
Release the button when the garage door opener lights blink or two
clicks are heard.
3.
Test by pressing the button you just programmed. The opener
activates.
PROGRAM TO ALL GARAGE DOOR OPENERS
1.
Press and hold the program button with the visor clip until the LED on
the front of the remote control turns on.
2.
Press and release the remote control button the number of times that
corresponds with the garage door opener type.
NOTE:
Make sure the
LED stops flashing between each press of the button.
# of Presses
Garage Door Opener Type
1
Yellow LEARN Button (S 2.0
®
)
2
Purple LEARN Button (315MHz S
®
)
3
Red/Orange LEARN Button (390MHz S
®
)
4
Green LEARN Button (390MHz Billion Code)
3.
Press the program button with the visor clip until the LED on the front
of the remote turns off.
4.
Choose from Options A, B, C, or D to complete programming.
Option A: Program Using the Push Button Door Control
5.
Press and hold the light button and the push button until the push
button LED begins to blink.
6.
Press and hold the button on the remote until the garage door lights
blink or two clicks are heard. Release the button. Programming is
complete.
7.
Test by pressing the button you just programmed. The opener
activates.
WARNING:
This product can expose you to chemicals including
lead, which are known to the State of California to cause cancer or
birth defects or other reproductive harm. For more information go
to www.P65Warnings.ca.gov.
Green or Red/Orange
LEARN Button
Purple
LEARN Button
Yellow
LEARN Button
Learn LED
Learn LED
Learn LED
Program Button
Push Button
Light Button
LED
