Strip wire 7/16" (11 mm)
7/16" (11 mm)
Red
Grey
White
Quick-Connect
Terminals
Antenna
To release wire, push in
tab with screwdriver tip
Door Control
Connections
Push Button
Light
Button
Lock
Button
WHT
RED
Bell Wire
Terminal
Screws
LOCK
LIGHT
Model 945C
Multi-Function Door Control
OWNERS INSTRUCTIONS
®
To prevent possible SERIOUS INJURY or DEATH from electrocution:
• Be sure power is not connected BEFORE installing door control.
• Connect ONLY to 24 VOLT low voltage wires.
To prevent possible SERIOUS INJURY or DEATH from a closing garage
door:
• Install door control within sight of garage door, out of reach of children
at a minimum height of 5 feet (1.5 m), and away from all moving parts
of door.
• NEVER permit children to operate or play with door control push
buttons or remote control transmitters.
• Activate door ONLY when it can be seen clearly, is properly adjusted,
and there are no obstructions to door travel.
• ALWAYS keep garage door in sight until completely closed. NEVER
permit anyone to cross path of closing garage door.
WARNING
CAUTION
WARNING
WARNING
Opener Terminal Screws
Antenna
Opener Panel
WHT
RED
Bell Wire
Terminal
Screws
Push Button
Light
Button
Lock
Button
LOCK
LIGHT
OR
Figure 2
Figure 1
© 2006, The Cham
b
erlain Gro
u
p, Inc.
114A2410D
All Rights Reser
v
ed
FOR USE WITH GARAGE DOOR OPENERS MANUFACTURED
AFTER JANUARY 1, 1995. To ensure proper functioning of
your opener, remove all old or previous push buttons/wall
control panels. Use only the enclosed door control for proper
operation.
Locate the door control
w
ithin sight of the door at a minim
u
m
height of 5 feet (1.5 m)
w
here small children cannot reach, and
a
w
ay from all mo
v
ing parts of the door and door hard
w
are.
INSTALLATION
The door control is typically attached directly to the
w
all. For
pre-
w
ired installations (as in ne
w
home constr
u
ction) it can
b
e
mo
u
nted to a standard single gang
b
ox.
1. Disconnect po
w
er to the garage door opener.
2. Strip 1/4" (6 mm) of ins
u
lation from one end of the
b
ell
w
ire and
connect to the t
w
o scre
w
terminals on the
b
ack of the door
control as follo
w
s: red/
w
hite
w
ire to 1 and
w
hite
w
ire to 2.
NOTE:
After installation, the indicator light behind the push
button cover will indicate proper connection.
3. Remo
v
e the p
u
sh
bu
tton co
v
er
b
y gently prying off the top edge
w
ith a scre
w
dri
v
er. Fasten
w
ith 6ABx1-1/4" self-tapping scre
w
s
(standard installation) or 6-32x1" machine scre
w
s (pre-
w
ired
installation) as follo
w
s:
•
(Standard Installation ONLY)
Drill pilot holes and install
b
ottom scre
w
, allo
w
ing 1/8" (3 mm) to protr
u
de a
b
o
v
e the
w
all
s
u
rface.
• Position
b
ottom of door control on scre
w
head and slide do
w
n
to sec
u
re. Adj
u
st scre
w
for sn
u
g fit.
• Install top scre
w
. Do NOT o
v
ertighten, yo
u
may damage the
plastic ho
u
sing.
4.
(Standard Installations ONLY)
R
u
n
b
ell
w
ire
u
p
w
all and
across ceiling to motor
u
nit. Use ins
u
lated staples to sec
u
re
w
ire
to
w
all and ceiling in se
v
eral places. Do NOT pierce
w
ire
w
ith a
staple, this
w
ill create a short or open circ
u
it.
5. Strip 7/16" (11 mm) of ins
u
lation from the end of the
b
ell
w
ire.
6. Connect
b
ell
w
ire to terminals as follo
w
s:
•
Quick Connect Terminals:
Red/
w
hite
w
ire to red terminal
and
w
hite
w
ire to
w
hite (Fig
u
re 1).
•
Screw Terminals:
Red/
w
hite to 1 and
w
hite to 2 (Fig
u
re 2).
7. Reconnect po
w
er to the garage door opener.
8. Replace the co
v
er
b
y inserting the
b
ottom ta
b
s and snapping it
into place. Test the
w
all control to ens
u
re proper operation.
OPERATION
Door Control Push Button:
Press to open or close the door.
Press again to re
v
erse the door d
u
ring the closing cycle, or to stop
the door
w
hile it is opening.
Light Feature:
Press the Light
bu
tton to s
w
itch the opener light on
or off.
W
hen the door is opened or closed, the light
w
ill remain on
for 4-1/2 min
u
tes. Press the Light
bu
tton to t
u
rn it off sooner. The
Light
bu
tton
w
ill not control the opener light
w
hen the door is in
motion.
Lock Feature:
Designed to pre
v
ent operation of the door from
porta
b
le remote controls. Ho
w
e
v
er, the door
w
ill open and close
from the Door Control p
u
sh
b
ar and from the Keylock and Keyless
Entry accessories.
To activate:
Press and hold the Lock
bu
tton for 2 seconds. The
p
u
sh
bu
tton indicator light
w
ill flash as long as the lock is on.
To turn off:
Press and hold the Lock
bu
tton again for 2 seconds.
The indicator light
w
ill stop flashing. Normal operation
w
ill res
u
me.
The Lock feat
u
re
w
ill also t
u
rn off
w
hene
v
er the Learn
bu
tton on
the opener end panel is acti
v
ated.
