2
gETTing STaRTED
The Universal Mini Remote Control can be programmed to activate up to two products, such as a garage door opener, MyQ
®
light
control, gate operator, or commercial door operator. each button on the remote control works independently of the other and must
be programmed separately. The images throughout this manual are for reference only and your product may look different.
Bottom Button
Garage door Opener
Commercial door Operator
Gate Operator
Led
you will need to locate the Program/LeaRn button on your product before you start programming.
GaRaGe dOOR OPeneRS
The Program/LEARN button is typically located on the back or side panel
of your garage door opener. Your Program/LEARN button may have a
different name (SMART button, SET button, etc.). For help locating your
Program/LEARN button refer to the Table of Contents in this manual or
contact your garage door opener manufacturer.
COMMeRCIaL dOOR OPeRaTORS
The RADIO button is typically located on the logic board of your operator.
For help locating your RADIO button contact your door operator
manufacturer.
GaTe OPeRaTORS
The Program/LEARN button is typically located on the control board of
your operator. Your Program/LEARN button may have a different name
(RADIO button, XMITTER button, etc.). For help locating your Program/
LEARN button contact your gate operator manufacturer.
exTeRnaL ReCeIveR
Some products do not
have a Program/LEARN
button. In this case, the
Program/LEARN button
will be located in an
external receiver. The
receiver will be located on
the product or mounted
nearby. Follow the
programming instructions
for an external receiver.
