Model DX77
Installation, Operation and Maintenance
Page
3
Rev 06/17/2020
DX77-IOM-A.doc
WARNING
Fig. 1 - General Specifications
V
ERTICAL
C
LEARANCE
Check the height of the area where the lift is to be installed.
Clearance should be calculated based on the full raised
height of the lift.
Failure by purchaser to provide
adequate clearance could result in
unsatisfactory lift performance,
property damage, or personal injury.
F
LOORING
Be certain you have the proper concrete floor to properly
handle the loaded lift. Floor should be in generally good
condition with no large cracks, spalling or deterioration.
Minimum requirements for concrete are 4 inches
minimum depth, with steel reinforcement, 3500 psi,
cured for 28 days per local commercial practice
. Floor
should be level within 3/8 inch over the installation area. No
anchors should be installed within 8 inches of any crack,
edge, or expansion joint. If these conditions cannot be met,
a pad may be poured to accommodate the lift.
Check with local building inspectors and/or permits office
for any special instructions or approvals required for your
installation.
Failure by purchaser to provide
the recommended mounting
surface could result in
unsatisfactory lift performance, property damage, or
personal injury.
L
OCATION
This lift has been evaluated for indoor use only with an
operating ambient temp. range of 5 – 40°C (41
–
104°F)
E
LECTRICAL
R
EQUIREMENTS
For lift installation and operation it is necessary to have a
dedicated circuit with circuit breaker or time delay fuse.
Refer to wiring diagram for circuit sizing.
S
AFETY
N
OTICES AND
D
ECALS
For your safety, and the safety of others, read and
understand all of the safety notices and decals included
here.
R
EAD ENTIRE MANUAL BEFORE ASSEMBLING
,
INSTALLING
,
OPERATING
,
OR SERVICING THIS
EQUIPMENT
.
P
ROPER MAINTENANCE AND INSPECTION IS
NECESSARY FOR SAFE OPERATION
.
DO
NOT
OPERATE A DAMAGED LIFT
.
Safety decals similar to those shown here are found on a
properly installed lift. Be sure that all safety decals have
been attached to the control console of the lift. Verify that
all authorized operators know the location of these decals
and fully understand their meaning. Replace worn, faded,
or damaged decals promptly.
Do not attempt to raise a
vehicle on the lift until the lift
has been correctly installed
and adjusted as described in this manual.
WARNING
WARNING
