SECTION 10
SLIDEOUT / LEVELING
10-4
Class A
SLIDEOUT
TROUBLESHOOTING
Problems Retracting the Room
Set the Park Brake if the red Park Brake light
flashes while pressing the Retract button.
If an error is detected on your DigiSync Room
Slide System, the green LED on the left side of
the control panel will blink an error code. If an
error code appears, see the Error Codes chart in
your InfoCase. The error code must be cleared
prior to operating the room. To clear the error,
press the “RESET” button. Before operating the
room after an error has been detected, check for
obvious faults such as obstructions prior to trying
to operate the room again. If the error code
appears again, the room will need to be retracted
using either the manual retraction method or the
fully manual method.
To retract the room after an error is detected,
you override the synchronization programming
and operate the room in the Manual Mode.
Further Information
See the DigiSync Slideout Room operating
guide included in your InfoCase for manual
mode, crank-in mode, and error codes.
Problems Extending the Room
Set the Park Brake if the red Park Brake light
flashes while pressing the Extend button.
Reset Button - push with toothpick or plastic rod
Green light will flash error code
CAUTION
Never let one side get more than 2 inches
(50 mm) ahead of the other while
retracting.