CGM 507A PINCERS MONO, Руководство пользователя

Страница: 2 / 14

-ENG-
HOW-TO DISASSEMBY (A) AND HOW-TO ASSEMBLY (B) THE VISOR
Disassembly of the visor and complete removal of the fixing system.
A1. Fully open the visor setting the hook A on upper position, as shown in Figure 1.
A2. Keep the lever B pulled to release the lock C and, at the same time, pull forward the visor to release
the hook A , as in Figure 2 .
A3. At this point pull the visor towards you to help the release of the lock D shown in
Figure 3 .
Figure 1. Figure 2. Figure 3.
Assembly of the visor and fixing system.
B1. Set the hook A on the upper position of the fixing system and set the hook E as in the Figure 4 .
B2. Hold in place the hook E and, using the visor retention system, pull forward the visor to fix the hook
A , as shown in the Figure 5
.
B3. Press the point indicated in Figure 6 to snap the locks of hooks C and D .
Figura 4. Figura 5. Figura 6.
NOTE. The figures refer to the components of the fixing system on the left side of the helmet. The
procedure is the same for the right side, where the components are specular.
CGM 507
CGM.507-A.01
HOW-TO REMOVE (A) AND HOW-TO FIX (B) THE INNER LINING
The main liner and the cheek pads can be easily removed for washing.
First remove the cheek pads and then the main liner.
A1. Remove the cheek pads by detaching the snap buttons and pulling the plastic flap ( Figure 7 ).
A2. Remove the main lining starting from the rear, by detaching the two snap buttons and pulling lightly
towards the inside of helmet, as in Figure 8 .
A3. Release the fixing plate from the plastic frame by pulling lightly on the three anchor points, starting
form one of the side points, as in Figure 9 .
A4.
To remove the chin protector simply pull out the plastic frame which it is fixed to the chin guard
slightly.
Figure 7. Figure 8. Figure 9.
First fix the main liner padding and then the cheek pads.
B1. Place the main liner padding inside the helmet with the fixing plate facing the front side, insert the
fixing plate in the frame and push to hook the anchor points as in the
Figure 10 .
Hook the two snap buttons on the rear side.
B2. Place the cheek pad in housing, by inserting the chin strap in its slot in advance. Then slide the plastic
flap between the shell and EPS liner, as in Figure 11a , taking care to slide the guide into the screw
between the shell and the EPS ( Figure 11b ). Finally, fasten the snap buttons ( Figure 12 ).
B3. To fix the chin protector simply hook the plastic frame to the base of the chin guard. slide the plastic
flap between the shell and EPS liner, taking care to restore the shell trim over the chin protector.
Figura 10. Figura 11a-11b. Figura 12.