CG emotron TSA Series, Инструкция по эксплуатации

Страница: 92 / 204

88 Functionality CG Drives & Automation, 01-5980-01r2
Communication Fault [264]
Main menu for communication fault/warning settings. For
further details please see the Fieldbus option manual.
Communication Fault Alarm Action
[2641]
Selects action if a communication fault is detected.
The following applies:
If RS232 or USB/RS485/BT is selected, the softstarter will
execute the selected action if there is no communication for
the time set in parameter [2642] “ComFlt Time”.
If Fieldbus is selected, the softstarter will execute the selected
action if:
1. the internal communication between the control board
and fieldbus option is lost for the time set in menu
[2642] “ComFlt Time”.
2. a serious network error has occurred.
Communication Fault Time [2642]
Defines the delay time for the trip/warning.
Ethernet [265]
Settings for Ethernet module (Modbus/TCP, Profinet IO).
For further information, see the Fieldbus option manual.
IP Address [2651]
MAC Address [2652]
Subnet Mask [2653]
Gateway [2654]
DHCP [2655]
Default: No action
No action 0 No communication supervision.
Hard Trip 1
For a definition, see Table 23, page 55. Soft Trip 3
Warning 4
NOTE: Menu [2151] or [2152] must be set to COM to
activate the communication fault function supervision.
Default: 0.5 s
Range: 0.1-15 s
2641 ComFlt AA
Stp
No action
2642 ComFlt Time
Stp
0.5s
NOTE: The Ethernet module must be re-booted to
activate the below settings, for example by toggling
parameter [261] from fieldbus to RS232 and back. Non-
initialised settings are indicated by a flashing display
text.
Default: 0.0.0.0
Read only
Default: A unique number for the Ethernet module.
Default: 0.0.0.0
Default: 0.0.0.0
Default: Off
Selection: On/Off
2651 IP Address
00 0. 00 0. 00 0. 00 0
2652 MAC Address
Stp
000000000000
2653 Subnet Mask
0. 00 0. 00 0. 00 0
2654 Gateway
0. 00 0. 00 0. 00 0
2655 DHCP
Stp
Off