CG emotron TSA Series, Инструкция по эксплуатации, Страница: 49 / 204

CG Drives & Automation, 01-5980-01r2 Operation via the control panel 45
6.4 Function keys
The function keys operate the menus and are also used for
programming and read-outs of all the menu settings.
6.4.1 +/- key function
To manually change a value or a selection, or to enter a new
value, the “+” and “-” keys are used. For this function to be
active, the keyboard must be unlocked (as it is by default),
menu [218].
Changing parameter selection
To change selection in a menu, press the “+” or “-” keys to
scroll between the available alternatives. The cursor to the
left (area E) is flashing while doing so. To confirm a
selection, press ENTER, and the cursor will stop flashing.
Editing parameter values
Most of the parameters can be changed during operation
without stopping the softstarter.
The parameters that can not be changed during operation
are in this manual marked with a lock symbol: .
• To change a parameter value, press the “+” or “-” keys.
The cursor to the left is flashing while the value is
increased or decreased. If you keep the “+” or “-” keys
pressed, the value will increase or decrease continuously.
• When altering large numbers you can also directly select
a digit with the cursor using the PREV and NEXT keys,
and change this with the “+” or “-” keys.
• Press the Toggle key to change the sign of the entered
value (only valid for certain parameters). The sign of the
value will also change when zero is passed.
• Press ENTER to confirm the value. The cursor to the
left will stop flashing.
• Press ESC to leave the edit mode.
Entering lock code
The lock code in menu [218] is inserted in a similar way as
changing parameter values by using the +/- keys, and the
cursor is moved with the PREV key to the left, in order to
enter the next symbol. When finished this is confirmed with
ENTER.
6.4.2 Jog key function
The “+” and “-” keys can be programmed for jogging,
enabling a manual jog start to be done from the control
panel by pressing and holding the key.
To activate the jog key function, see instructions in “Jog
functions” on page 50.
To deactivate the jog key function, unlock the keyboard in
menu [218].
Table 19 Function key commands.
ENTER
Step to lower menu level.
Confirm a changed setting.
ESCAPE
Step to higher menu level.
Ignore a changed setting (with-
out confirming).
PREVIOUS
Step to previous menu within
the same level.
Move cursor one position to the
left.
NEXT
Step to next menu within the
same level.
Move cursor one position to the
right.
- (MINUS)
or
JOG REV
Decrease a value.
Change a selection.
Or:
Jog reverse function.
+ (PLUS)
or
JOG FWD
Increase a value.
Change a selection.
Or:
Jog forward function.
NOTE: If you try to change a function during operation
that only can be changed when the motor is stopped, the
message “Stop First” is displayed.
NOTE: The lock code is fixed and set to 291.
NOTE: If the message “CP Locked!” is shown or if
nothing happens when pressing the “+” or “-” key the
control panel is locked, go to menu [218] to unlock the
control panel.