CG emotron TSA Series, Инструкция по эксплуатации

Страница: 25 / 204

CG Drives & Automation 01-5980-01r2 Connections 21
Fig. 17 Board layout for Emotron TSA .
Emotron TSA connections and details
1. Control supply voltage connection PE, N, L (power
board).
2. Earthing plane with slots for tie wraps for fixation and
securing of control signal cables and option board cables.
This plane is connected to earth for earthing of shielded
option board cables.
3. S1 jumper for U/I selection of analogue input
4. Option board ribbon cable connector
5. Communication module (option)
6. LED indicators (visible through perforation):
- Red and yellow for communication signals
- Green indicating power on
7. Clock battery
8. Terminals for DigIn/AnIn/AnOut signals (control
board)
9. Terminals for relay output signals and PTC connection
(power board)
10. RS232, using 9-pin female D-sub connector. For
temporary connection of a personal computer or
connection of external control panel (option). For
permanent connection of a personal computer you have
to use one of the isolated communication option boards
RS485 or USB, see also Note below.
4
3
6
7
1
9
8
2
10
5
WARNING!
For safety reasons the protective earth (PE)
for the control supply must be connected.
NOTE: This RS232 connector is not galvanically isolated.
It is therefore important that all externally connected
equipment to the control board are on the same
potential level. Otherwise equipment may be damaged!
If uncertain, we advice you to use the isolated USB
option instead or to use an isolated USB to RS232-
converter.
Table 11 Control signal cable dimension and stripping lenght
TSA size
Max. Cable
dimension
[mm
2
(square feet)]
Recommended
stripping length
[mm (in)]
1 - 4
Flexible: 1.5 (16)
Solid: 2.5 (27)
6 (0.23) (*
* When using Ferrules, suitable Ferrule length is 10-12 mm/
0.39 - 0.47 in.