Ceyear 1465 Series, Руководство по программированию

Страница: 87 / 143

3 SCPI
3.3 Instrument subsystem command
80
Parameter:
<Mode> Discrete data. Options for PM output waveform are:
SINE Sine,
SQUare Square,
TRIangle Triangle,
RAMP Zigzag,
NOISe Noise,
SWEPtsine SweepSinc,
DUALsine DualSinc.
Example: [:SOURce]:FM:INTernal:SHAP RAMP PM waveform is zigzag.
Reset status: SINE
Key Entry:
【 FM/ΦM 】 —>[Basic Config]—>[PM Waveform]
[:SOURce]:PM:INTernal:SWEep:TIME <Time>
Function: This command is used for setting sweep time when FM Waveform is set to SweepSinc.
Setting format: [:SOURce]:PM:INTernal:SWEep:TIME <val>
Query format: [:SOURce]:PM:INTernal:SWEep:TIME?
Parameter:
<Time> Sweep time when PM Waveform is set to SweepSinc.
Range: 10.000ms [10.000us
，
2s].
Example: :PM:INTernal:SWEep:TIME 1s
Sweep time of sweep sine for PM signal is 1s.
Reset status: 10.000us
Key Entry:
【 FM/ΦM 】 —>[Sweep Sinc]—>[Sweep Time]
[:SOURce]:PM:SOURce <Mode>
Function: This command is used for setting PM Sourcemodes, which include: Internal and External.
When it is set to External, the external PM signal should be connected to the FM/PM
input interface on the front panel of the signal generator.
Setting format:
[:SOURce]:PM:SOURce EXTernal|INTernal‘
Query format: [:SOURce]:PM:SOURce?
Parameter:
<Mode> Discrete data. Options for PM Source mode are:
EXTerna External,
INTernal Internal.
Example: :PM:SOURce INT PM Source is set to Internal.
Reset: INT
Key Entry:
【 FM/ΦM 】 —>[PM Source]—>[PM Source]
[:SOURce]:PM:STATe <State>
Function: This command sets the PM signal output state of the signal generator.
Setting format: [:SOURce]:PM:STATe ON|OFF|1|0