Ceyear 1465 Series, Руководство по программированию

Страница: 62 / 143

3 SCPI
3.3 Instrument subsystem command
55
Key Entry:
【
Frequency
】 —>[LF Out]—>[LF Waveform]—>[Zigzag>>]
[:SOURce]:LFOutput:SHAPe <Mode>
Function: This command sets LF signal output waveform. There are seven waveforms for selection:
Sinc, Square, Triangle, Zigzag, White noise, SweepSinc and DualSinc.
Setting format: [:SOURce]:LFOutput:SHAPe SINE|SQUare|TRIangle|RAMP
|NOISe|SWEPtsine|DUALsine
Query format: [:SOURce]:LFOutput:SHAPe?
Parameter:
<Mode> Discrete data. LF Waveform is as follows:
SINE Sine,
SQUare Square,
TRIangle Triangle,
RAMP Zigzag,
NOISe Noise,
SWEPtsine SweepSinc,
DUALsine DualSinc.
Example: :LFOutput:SHAPe TRIangle LF waveform of the signal generator is triangle.
Reset status: SINE
Key Entry:
【
Frequency
】 —>[LF Out]—>[LF Waveform>>]
[:SOURce]:LFOutput:STATe <State>
Function: This command is used for setting LF Output of the signal generator.
Setting format: [:SOURce]:LFOutput:STATe ON|OFF|1|0
Query format: [:SOURce]:LFOutput:STATe?
Parameter:
<State> Boolean data is as follows:
ON | 1: LF Output is turned on, and LF signal output is turned on accordingly.
OFF | 0: LF Output is turned off, and LF signal output is turned off accordingly.
Example: :LFOutput:STATe OFF Turn off LF signal output.
Reset status: 0
Key Entry:
【
Frequency
】 —>[LF Out]—>[LF Output ON OFF]
[:SOURce]:LFOutput:SWEep:TIME <Time>
Function: This command is used for setting sweep time when LF Waveform is set to SweepSinc.
Setting format: [:SOURce]:LFOutput:SWEep:TIME <val>
Query format: [:SOURce]:LFOutput:SWEep:TIME?
Parameter:
<Time> Sweep time of sweep sine.
Range: 10ms[100us
，
2s].
Example: :LFOutput:SWEep:TIME 200ms Sweep time of sweep sine is set to 200ms.
Reset status: 10ms