3300IP VoIP Phone | User Manual
www.CetisGroup.com
17
Reference – Quick Keys
The TeleMatrix family of SIP phones has
implemented an innovative way to determine
various states of the SIP phone and the
network it is attached to via the phone’s dial-
pad. By pressing the * key twice in
succession followed by a series of numbers
(generally matched to the command’s
corresponding letters.)
Many of these features are newly added in Firmware 1.8.0 and higher.
Show IP address - **47# (**IP#)
Description: Keying **47# causes the phone to read out the IP address currently assigned. If the phone has an
LCD panel, it should be displayed there. If the phone has no display panel, or the address cannot be displayed,
it should be read out audibly on the speaker (or handset if off hook.)
Show VLAN - **85# (**VL#)
Description: When entered respond with the Voice VLAN ID. If VLAN is disabled “Zero” to indicate “off” is
spoken.
Set VLAN - **87# (**87*password*VLANid#)
Description: This allows the user to set the VLAN ID. The keypad password is also required. To set the VLAN
ID when the password is 9382 and the VLAN ID is 30, enter "**87*123*301#". When a VLAN ID is set, the
phone should set VLAN Enabled and the Voice VLAN ID. If necessary the LAN should be set to Bridge mode
also.
Show Firmware Version - **39# (**FW#)
Description: When **39# is entered, the phone will display or audibly respond with the firmware version number
such as "1.7.240.235".
Show TFTP Server Address - **83# (**TF#)
Description: When entered, the phone responds with the IP address of the TFTP
server. This should be the TFTP server address being actually used. It might come from the configuration file,
option 66, option 125 or option 43.
Re-program New ConfigID - **77*password*ConfigID# (**RP*xxx*yyyy#)
Description: After entering **77*, the user must enter the Keypad Password followed by a * then the ConfigID of
the new config file, followed by #. If the password (in the existing config on the phone is 123, and the new
config file is 1234.3300ip.txt), then the user would enter **77*123*1234#. The user should NOT be prompted
for the password. The phone will then download the new config file 1234.3300ip.txt.
Reset phone to Factory Default – **33*<password># = (**DE*123#)
Description: After entering **33*123#, the phone will reset to factory default, which implies that there is no
programming information current, and the phone will prompt for a ConfigID at reboot.
Re-boot phone (without reset) – **72# (**RB#)
Description: After entering 72#, the phone will reboot
SIP TeleWorker Config File Download – **89*<tftp server IP address>*<ConfigID>#
Description: To download a config file for a phone remotely, this **TW code is used for designating a tftp server
IP address and configID to download.
