Cetetherm AquaEfficiency EFB112 DD, Инструкция по установке, обслуживанию и эксплуатации

Страница: 37 / 86

Cetetherm AquaEfficiency
Installation, service and operating instruction
35
11.3 Configuration menu
Remark:
After resetting the controller, this sub menu should be accessed to configure pumps’ number.
Parameter Factory
Default
Setting Optional setting Description
Type 0=First 1=EFF 0 0= Aqua First
1= AquaEff
Set to 1
S5 Active heating
1)
0 0 Disables /
1 Enables heat
curve
Set to 1 to activate
S5 Menu Outdoor Temperature
Cooling Mode AO1 0 0=Heating mode/
1= Cooling Mode
Invert 0-10V signal on primary valve
P12 Nbr of Pumps 0 0/1/2 Primary pump(s) number
MinSpeed P1P2 40 10->100
Minimum primary pumps’ signal
40% for AquaEfficiency
50% for SolarFlow
N/A for other products
P34 Nbr of Pumps 0 0/1/2 Secondary pump(s) number
Modbus Factor 1 1/10/100 To set displayed decimals on Modbus
values.
1=integer value, eg:58°C
10=1 decimal, e.g. 583/10=58,3°C
100=2 decimals, e.g. 5836/100=58,36°C
Relay 1 function
2)
1 0..7 0=No action
1=General Default (GD)
2=High temp Alarm (HA)
3=Eco function (E)
4=Booster function (B)
5=Thermal Treatment (TT)
6=Pump Fault (PF)
7=Tank loaded (TL).
Relay 2 function 2) 2 0..7
Renewable Config
0:N 1:SF 2:AA 3:AP
2)
0 0/1/2/3 0=Not used
1=application SolarFlow (SF)
2=application AlfaStore A
3=application AlfaPilot
APilot Rev 0=Off 1=On 0 0/1 0/1 (depends of valve type)
1= application AlfaPilot
SP_distrib 0=I 1=E 0 0/1 0/1 : internal / External for Modbus use
(for Pt2 only)
SW AL Version xx N/A Firmware Version
1)
If the parameter “S5 Active heating” is set to 1, the secondary outlet temperature set point, called
“S1_PID_Setpoint”, will be calculated by the heat curve, as a function of the outdoor temperature (S5),
see
11.8 S5 Menu Outdoor Temperature .
2)
These three parameters define the renewable mode, please see 11.14