CETAC Aridus II, Руководство оператора

Страница: 13 / 62

13
3 Installing the
Aridus II™
To install the Aridus II
™
, you must complete the tasks described in this chapter.
Ensure that the AC power is off (0 showing at the bottom edge of the
power switch) on the back of the Aridus II
™
before proceeding with
installation.
Establishing External Connections
The first step in the installation process involves connecting the Aridus II
™
to
the power source and to the ICP-MS instrument. The following sections
explain how to establish these connections.
Connecting the Aridus II
™
to the Power Source
Voltage-specified power cords are supplied with each Aridus II
™
.
Use only these power cords or exact replacements.
To connect the Aridus II
™
to a power source, plug the cord into the power
module located on the back panel of the Aridus II
™
. Then plug the cord into an
appropriate AC outlet (110 or 220 VAC
±
10%, 50/60 Hz depending on the
voltage selection).
Connecting the Aridus II
™
to the ICP-MS
Depending on the ICP-MS manufacturer and model, a torch adapter is supplied
for interfacing the Aridus II
™
to the ICP-MS. Adapters are available for all ICP-
MS instruments.
1
A length of ¼
"
O.D. Teflon
®
-lined PVC tubing is connected to the torch adapter.
Place the other end of this tubing onto the SAMPLE OUT port located on the
back of the Aridus II
™
. This end will be equipped with a threaded nut for
WARNING
WARNING