background image

*

C

E

T

 i

a

 t

ra

d

e

m

a

rk

 o

C

E

T

 F

ir

e

 P

u

m

p

M

fg

 L

td

.

75 Hector St., P.O. Box 90, Pierreville (Québec) Canada  J0G 1J0      Telephone: 1-800-567-2719      Fax: 1-800-434-2613      

www.fire-pump.com

ACCEPT ONLY THE BEST

A   C E N T U R Y   O F   E N G I N E E R I N G   F O R   T H E   B R A V E S T

PFP-20hp-KHL-HP

INSTRUCTIONS  MANUAL

Congratulation, you have just purchased a C.E.T. portable pump.  If you follow the procedures in this
operation manual, it will give you years of use without any problems.

ENGINE SPECIFICATIONS

• Kohler 20hp at 3600 RPM, air cooled engine.
• V-Twin cylinder gasoline engine.
• 12V Electric start with recoil start as backup.
• 6 gallon (22 l) detachable fuel tank.  The fuel tank is made from plastic.

PUMP UNIT SPECIFICATIONS

• Transmission drive C.E.T. single stage centrifugal pump.
• Pump body made from resistant aluminum alloy.
• Bronze impeller.
• Mechanical shaft seal.
• Stainless steel pump shaft.
• Belt drive transmission.
• Exhaust priming system, guaranteed up to 15’ (4.5 meter) lift.
• One 1 1/2” (38 mm) delivery outlet with 1/4-turn ball valve.
• One 2 1/2 ” (65 mm) suction inlet.
• Dimensions : Length : 22” (558 mm); Width : 25” (635 mm); Height : 23” (584 mm).
• Weight : 180 lbs (81 kg).

INCLUDED ACCESSORIES

• 36 watt alternator.
• Low oil alert.
• Pressure gauge.
• 12-V battery.

PERFORMANCE

160 GPM (605 LPM)  @  50   PSI   (3.5 bar)
125 GPM (473 LPM)  @  100 PSI   (6.9 bar)
90 GPM (340 LPM)    @  150 PSI   (10.3 bar)
60 GPM (227 LPM)    @  200 PSI (13.8 bar)
30 GPM (113 LPM)    @  250 PSI (17.2 bar)

Your pump comes with a full year warranty on all mechanical components.

Содержание PFP-20hp-KHL-HP

Страница 1: ...detachable fuel tank The fuel tank is made from plastic PUMP UNIT SPECIFICATIONS Transmission drive C E T single stage centrifugal pump Pump body made from resistant aluminum alloy Bronze impeller Mechanical shaft seal Stainless steel pump shaft Belt drive transmission Exhaust priming system guaranteed up to 15 4 5 meter lift One 1 1 2 38 mm delivery outlet with 1 4 turn ball valve One 2 1 2 65 mm...

Страница 2: ...with less than 12 in of water below the inlet of the suction hose Allow your pump to run without surveillance Run the pump with the discharge valve closed for more than 1 minute STARTING PROCEDURE Place your pump on a hard stable surface within 15 from horizontal Check the oil Check the gas tank level Connect your suction hose Make sure that there is a rubber seal on the adapter and screw it tight...

Страница 3: ...ump will help prevent the pump from seizing up TROUBLESHOOTING Before calling us try the following if your pump does not operate properly If the venturi does not work properly Check the exhaust port it should be closed tightly without any exhaust gas whistling out between the seal and the pipe Check the casing drain valve it should be closed Check any air leakage from suction hose If the engine se...

Страница 4: ...or improperly maintained or for equipment which has been returned for inspection or repair more than ten 10 days after defect complained of has been or should have been discovered by the Purchaser or Equipment which is operated after the defect has been discovered 3 CET incurs no liability for alteration or repairs unless the Purchaser first receives CET written consent or approval CET will not be...

Отзывы: