10 Firmware update
10.1 Automatic firmware updates
Automatic firmware update after installation
The first firmware update after installation should be carried out manually. However, if this has
not happened, the firmware update is carried out automatically after the device has been
operated by the CESeasy App. In this case, the CESeasy app shows a message, and the firmware
update will be completed after approx. 45 seconds.
Automatic firmware updates during operation
Firmware updates are automatically transmitted during operation by the CESeasy app. As soon as
the new firmware has been transmitted completely, the device operates on the new firmware.
Usually you do not notice the updating process.
10.2 Manual firmware updates
The following situations require a manual firmware update:
l
The motor cylinder has been installed for the first time
l
The motor cylinder has been reset to factory settings
How to proceed
See
Make sure that you have carried out the
first
firmware update
before
configuring the device.
Otherwise, your configuration will be overwritten by
the first firmware update. No subsequent firmware
updates will overwrite your configuration.
A message is shown that the transmitted firmware
has been installed once the firmware has been
transmitted completely. The motor cylinder emits a
signal to indicate that the firmware installation has
been completed. Firmware installation takes about 30
seconds.
Page 34 of 53
CESeasy motor cylinder
10 Firmware update
